Skip to product information
1 of 3

Ozark Engineering

tRCtor - Frame Kit

tRCtor - Frame Kit

Regular price $2.00 USD
Regular price Sale price $2.00 USD
Sale Sold out
Shipping calculated at checkout.

This is a bare frame kit containing the three parts you will need to print in order to assemble the tri-barrel tRCtor frame used in Proto-1. You will need to purchase the following parts to complete the assembly:

- 1x 5' section of 2" PVC pipe

- 12x M3x10 screws

The following fabrication will need performed:

- Cut the PVC into three even segments. (Our examples use 18" frame tubes).

- Drill twelve 7/64 holes in the pipe using nose-cap and frame mid-points as jigs. It is recommended to lay the frame upside-down on a level surface and start with the bottom pipe to ensure all holes are even.

We recommended that you wait to drill the 'Frame Lock' holes until you have installed drive arms, as the forward mid-point holds the drive arms in place, and the set screws ensure consistent tolerances at the suspension pivot points. The rear-midpoint is typically used to locate auxiliary/temporary modules between itself and the rear-steering perch, or not used at all as the current rear steering module provides adequate locking points. 

View full details

The Creek Craft

Fun to build, fun to operate, fun to share!